Measurement-computing USB-ERB24 Bedienungsanleitung PDF herunterladen (Seite 12)

USB-ERB24 User's Guide Installing the USB-ERB24

Unpacking the USB-ERB24

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the USB-ERB24 from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If your USB-ERB24 is damaged, notify Measurement Computing Corporation immediately by phone, fax, or e-

mail. For international customers, contact your local distributor where you purchased the USB-ERB24.

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

 Fax: 508-946-9500 to the attention of Tech Support

 Email: [email protected]

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Installing the USB-ERB24

The USB-ERB24 has two on-board switches that you set to configure the relay logic polarity and the resistor

pull-up/down configuration. Configure these switches before you connect the external power supply to the

USB-ERB24. Factory-configured default settings are listed in . Refer to Fi for the location of

each switch on the USB-ERB24.

Table 2-1

Table 2-1. Default switch configuration

gure 3-1

Figure 3-1

Configuring the hardware switches

The USB-ERB24 has two on-board switches that you set to configure the relay control logic polarity and the

relay power-on state. Factory-configured default settings are listed in . Refer to for the

location of each switch on the USB-ERB24.

Board label Description Default setting

INVERT NON-INVERT

Configures the relay control logic parity per relay bank for invert or

non-invert logic.

Non-invert

Pull DOWN PULL UP

Configures the relay power-on state per relay bank for pull-up or

pull-down.

Pull-down

Each DIP switch sets the configuration of one relay group. The DIP switch labeled A configures relays 1 to 8,

the switch labeled B configures relays 9 to 16, the switch labeled CL configures relays 17 to 20, and the switch

labeled

CH configures relays 21 to 24 ( ). Figure 2-3

Figure 2-3. Typical board switch

Configures 9-16relays

Configures relays17-20

Configures relays21-24

Port A consists of relays 1 through 8, Port B consists of relays 9 through 16, Port CL consists of relays 17

through 20, and Port CH consists of relays 21 through 24.

Remove from the enclosure to access the on-board switches

To change the configuration of a switch, you must first remove the USB-ERB24 from the enclosure.

2-2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Measurement-computing USB-ERB24 Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Measurement-computing USB-ERB24