Measurement-computing LogBook Series Bedienungsanleitung PDF herunterladen (Seite 186)

A-2 Supplement / HopNet Modems 887997 LogBook User’s Manual, Appendix A

Configuration via LogBook Software

In order to accommodate the necessary configurations, we must specify alias names in the Logbook

Configuration Applet.

In the LogBook Configuration Applet [located in the Windows Control Panel] we will see four “Port

Setups.” Each will need configured to ensure proper serial port communications via the HopNet modem.

The four devices are:

• Parallel Port Setup – necessary to establish communication for setting up the serial port

• Serial Port Setup – this is the “Standard Serial Port Setup” for LogBook

• Serial Port Fixed Baud Rate Setup – for LogBook

• Serial Port Fixed Baud Rate Setup – for HopNet

Configure the “Parallel Port Setup” for Device: LogBook Parallel

1. Navigate from the Windows Desktop as follows:

Start ⇒ Settings ⇒ Control Panel ⇒ LogBook Config

2. Double-click on the LogBook Config icon to open the applet.

3. Click <Add Device>.

4. Set the Properties, via the LogBook Properties Tab, as follows:

Device Name: LogBook Parallel

Connection Type: Parallel Port

Device Connection: LPT1

Protocol: ECP

5. Click the <APPLY> button.

6. Click the <OK> button.

Configure the “Serial Port Setup” for Device: LogBook Serial

1. From the LogBook Configuration Applet, click <Add Device>.

2. Set the Properties, via the LogBook Properties Tab, as follows:

Device Name: LogBook Serial

Connection Type: Serial Port

Device Connection: COM1

Protocol: RS232

3. Set the Properties via the Port Settings Tab, as follows:

Bits per second: 38400

Flow control: Hardware

4. Click the <APPLY> button.

5. Click the <OK> button.

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 221 222

Keine Kommentare

Measurement-computing LogBook Series Bedienungsanleitung Seite 186