Measurement-computing CIO-EXP-GP Bedienungsanleitung PDF herunterladen (Seite 6)

3 GENERAL CONFIGURATION

3.1 A/D Board Type Select Jumper

The CIO-EXP-GP can be used with either DAS08 or DAS16 family boards because the signal

assignments of the 37-pin connectors match those of the DAS08 and may be adapted to those of the

DAS16 with a C-EXP2DAS16-10 cable. Select the A/D board type via the JB10 jumper.

Jumper JB10 on the ,CIO-EXP-GP located near the 37-pin connector, selects the

A/D board family as DAS08 or DAS16.

Figure 3-1 shows the jumper set to use the CIO-EXP-GP with a CIO-DAS08

family board.

Figure 3-1

DAS Family Select

3.2 Setting The Output Channel

Jumpers labeled “CH SEL” located near the 37-pin connector select the A/D board channel that the

output from the active sensor will be connected to.

37-Pin

CONNECTORS

OUTPUT CHANNEL

SELECT JUMPER

AMP

GAIN

1 OR 2.5

MUX ADDR 1

MUX ADDR 2

MUX ADDR 3

INPUT 0

INPUT 1

INPUT 2

INPUT 3

INPUT 4

INPUT 5

INPUT 6

INPUT 7

8-CHANNEL MULTIPLEXER

P1 & P2

Figure 3-2. Output Channel Select Jumper

1 2 3 4 5 6 7 8 9 10 11 ... 45 46

Keine Kommentare

Measurement-computing CIO-EXP-GP Bedienungsanleitung Seite 6