Measurement-computing WiFi-500 Sensor Series Quick Start Bedienungsanleitung PDF herunterladen (Seite 5)

Setting up the device on the PC

When a CONNECTED message displays, the sensor has connected to the

selected WiFi network.

The device configuration instructions differ depending on whether you are

storing data on the PC (

Setting up the Sensor on the PC below) or on the

cloud (

Setting Up the Sensor for the Cloud on page 8).

Setting up the device on the PC

Complete the following steps to set up a WiFi-500 Sensor Series device to

store data on a PC:

1. Configure the device name logging settings on the GENERAL

SETTINGS

dialog box and click Next.

2. Configure the TEMPERATURE ALARMS settings.

If you are setting up a device that supports thermocouple probes, select

your probe type.

Refer to the label attached to the probe cable for the probe number.

Selecting an incorrect probe type can cause inaccurate measurements.

Figure 1: Probe type label

Click Next.

4. If your WiFi-500 Sensor Series device measures humidity, configure

the

HUMIDITY ALARMS settings and click Next.

5. Disconnect the USB cable from the device and click Next in the

Set-Up Complete

dialog box.

6. Click Finish and place the device in the location you want to monitor

(refer to

Positioning the device on page 12)

1 2 3 4 5 6 7 8 9 10 ... 13 14

Keine Kommentare

Measurement-computing WiFi-500 Sensor Series Quick Start Bedienungsanleitung Seite 5