Measurement-computing PointScan 300 Series rev.1.0 Bedienungsanleitung PDF herunterladen (Seite 11)

PointScan/300 User’s Manual

9-26-01

Overview 1-5

Getting Started With PointScan/300 Series Hardware

Following these steps will make installation and start-up easier.

nMount the Hardware

If you purchased individual PointScan/300 Series components, refer to Section 2 for information on

installation instructions.

oInstall PT-BUS Wiring Between Modules

Make PT-BUS wiring connections between the PointScan/300 Series modules.

Refer to Section 3 for PT-BUS wiring guidelines.

p Connect Power and I/O Wiring to the Modules

Connect AC power to the PointScan/300 Series power supply. Make DC power connections from the

power supply to the gateway and I/O modules (as needed.) Make field wiring connections to the

PointScan/300 Series I/O modules and any peripheral equipment. Refer to the individual module sections

in this manual for connection details.

qInstall Communication Cabling

If you did not purchase a factory communication cable (CA-22), install a RS232 cable between your

computer and serial port on the PointScan/300 Series gateway.

Fabricate and install RS232, RS422 and RS485 cables as needed. If you are using Ethernet gateways,

(PointScan/442) install the correct cabling and peripherals. Refer to the documentation for your Ethernet

communication devices for details.

r Apply Power

Power up the PointScan/300 Series I/O and related peripherals. Observe the status LED on each module.

The normal conditions are as follows:

Module Type

LED, Normal Indication

Gateway (PointScan/442) Power and Status LEDs On

I/O modules PointScan/300 Series

in user enclosure

Status LEDs Blinking

PointScan/443 Power LED on

s Configure Using IO Toolkit

Refer the steps outlined in the online help for each PointScan/300 Series module.

t Test the System

Use the Test I/O window in the IO Toolkit program to verify proper I/O operation in all PointScan/300

Series module.

u Configure Your Computer

Refer to the on-line help in the IO Toolkit for more information.

v Run the (Citec) Software

Refer to the on-line help in the Citec software for more information.

w If You Have Difficulty

If you experience startup trouble, contact IOtech at productsupport@iotech.com.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

Measurement-computing PointScan 300 Series rev.1.0 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Measurement-computing PointScan 300 Series rev.1.0