Measurement-computing Digital488/80A Bedienungsanleitung PDF herunterladen (Seite 43)

Handshake Lines

IEEE 488 interface uses three handshake lines in an "I'm ready - Here's the data - I've got it" sequence

handshake

The .

This protocol assures reliable data transfer, at the rate determined by the slowest Listener. One

lled by the Talker, while the other two are shared by all Active Listeners. The handshake

e other IEEE 488 lines, are active low.

Talker then outputs data on the bus and waits until

NRFD is unasserted (high) which indicates that all

addressed Listeners are ready to accept the information. When

NRFD and NDAC are in the proper state,

the Talker asserts

DAV (active low) to indicate that the data on the bus is valid.

• Not Ready for Data (

NRFD): The NRFD line is used by the Listeners to inform the Talker when they

are ready to accept new data. The Talker must wait for each Listener to unassert this line (high) which

they will do at their own rate when they are ready for more data. This assures that all devices that are

to accept the information are ready to receive it.

• Not Data Accepted (

NDAC): The NDAC line is also controlled by the Listeners. This line indicates to

the Talker that each device addressed to Listen has accepted the information. Each device releases

NDAC (high) at its own rate, but the NDAC will not go high until the slowest Listener has accepted the

data byte.

Data Transfer Lines

To transfer bit-parallel/byte-serial information between devices on the bus, the IEEE 488 interface provides

eight data lines (

DIO1 through DIO8). These data lines are bidirectional and are active low.

line is contro

lines, like th

• Data Valid (

DAV): The DAV line is controlled by the Talker. The Talker verifies that NDAC is asserted

(active low) which indicates that all Listeners have accepted the previous data byte transferred. The

Digital488/80A User’s Manual IEEE 488 Background 37

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Keine Kommentare

Measurement-computing Digital488/80A Bedienungsanleitung Seite 43