Measurement-computing CIO-DO24DD Bedienungsanleitung PDF herunterladen (Seite 8)

Table 3-1. PC I/O Addresses

SERIAL PORT3F8-3FFEGA2B0-2BF

FLOPPY DISK3F0-3F7PARALLEL PRINTER270-27F

SERIAL PORT3E8-3EFALT BUS MOUSE23C-23F

CGA3D0-3DFBUS MOUSE238-23B

EGA3C0-3CFEXPANSION UNIT (XT)210-21F

PARALLEL PRINTER3BC-3BFGAME CONTROL200-20F

MDA3B0-3BBHARD DISK (AT)1F0-1FF

SDLC3A0-3AF80287 NUMERIC CO-P (AT)0F0-0FF

SDLC380-38F8237 #2 (AT)0C0-0DF

PARALLEL PRINTER378-37FNMI MASK (XT)0A0-0AF

HARD DISK (XT)320-32F8259 PIC #2 (AT)0A0-0A1

PROTOTTYPE CARD310-31FDMA PAGE REGISTERS080-08F

PROTOTYPE CARD300-30F

CMOS RAM & NMI MASK (AT)

070-071

SERIAL PORT2F8-2FF8742 CONTROLLER (AT)060-064

SERIAL PORT2E8-2EF8255 PPI (XT)060-063

GPIB (AT)2E0-2E78253 TIMER040-043

EGA2D0-2DF8259 PIC #1020-021

EGA2C0-2CF8237 DMA #1000-00F

FUNCTIONHEX

RANGE

FUNCTIONHEX

RANGE

The CIO-DO24DD BASE switch can be set for address in the range of 000-3FC so it

should not be hard to find a free address area for CIO-DO24DD. Once again, if you

are not using IBM prototyping cards or s ome other board which occupies these

addresses, then 300-31F HEX are free to use.

Addresses not specifically listed, such as 390-39F, are not reserved and may be

available. Check your computer for other boards which may use I/O addresses.

3.2 INSTALLING IN THE COMPUTER

1. Turn the power off.

2. Remove the cover of your computer. Please be careful not to dislodge any of the

cables installed on the boards in your computer as you slide the cover off.

3. Locate an empty expansion slot in your computer.

4. Push the board firmly down into the exp ansion bus connector. If it is not seated

fully it may fail to work and could short circuit the PC bus power onto a PC bus

signal. This could damage the m otherboard in your PC as well as the

CIO-DO24DD.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Keine Kommentare

Measurement-computing CIO-DO24DD Bedienungsanleitung Seite 8