
Getting Started, pg. 16
11-01-01
ZonicBook
12.
Click <Next>.
The Hardware Wizard is now ready to install the DSP-card driver
(see following figure).
13.
Click <Next>.
14.
After the device driver has been installed, click <Finish> (following figure).
This completes the driver installation for Windows Me. Your computer is now ready to run
ZonicBook software and communicate with the ZonicBook module.
Reference Note:
You can use the Windows Control Panel to verify that the DSP-card has been installed
correctly. See, Verifying the DSP-Card has been Correctly Installed, on page 19.
Windows Me Users
Kommentare zu diesen Handbüchern