Measurement-computing ZonicBook 618E rev.3.4 Bedienungsanleitung PDF herunterladen (Seite 75)

Trigger Input & Clock Input 8

Trigger Input – Available for eZ-Analyst only

Clock Input – Reserved for future use

Trigger Input and Clock Input BNC Connectors

The top row of the front panel includes a Trigger Input BNC and Clock Input BNC connector. Other connectors

are discussed elsewhere.

Trigger Input

The ZonicBook/618E includes a Trigger Input BNC. This TTL compatible trigger input applies only to the

ZonicBook/618E when eZ-Analyst is being used.

The Trigger Input can be used to:

• trigger the start of a data acquisition

• trigger the start of recording data

• trigger both the start of an acquisition and the start of data recording at the same instant

Connector: BNC, labeled TRIGGER INPUT

Input Signal Range: 0 to 5V, TTL compatible

Input Characteristics: TTL compatible with 10K Ohm pullup resistor

Latency: 300 ns max

Reference Notes:

¾ For information regarding the use of an analog input channel (CH1 through CH8)

as a trigger, refer to the Analog Triggers section of chapter 6 in this document.

¾ For information regarding eZ-Analyst and trigger input, refer to the eZ-Analyst

Software Reference Manual, p/n 1086-0922.

Clock Input

The Clock Input BNC is reserved for future use.

ZonicBook/618E 929895 Trigger Input & Clock Input 8-1

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 121 122

Keine Kommentare

Measurement-computing ZonicBook 618E rev.3.4 Bedienungsanleitung Seite 75