Measurement-computing PCI-COM232 Bedienungsanleitung PDF herunterladen (Seite 10)

Figure 2-3. PCI-COM232 Windows NT Control Panel Configuration

2.5.3 Resetting Extended Baud Rate Selection on Power Up

The PCI-COM232 board will power up with the UART Clock Rate set to 1.8432 MHz. If you change the

UART Clock Rate via the Device Manager Property Page (in Windows 95 or 98) or via the PCIcom

applet (in NT), you must execute the

ComSet32.exe

application to restore the settings after a reboot. The

Device Manager configuration dialog writes the chosen settings to the registry. The

ComSet32.exe

application reads the settings from the registry and restores the PCI-COM232 hardware configuration.

During installation, the user has the option to install a shortcut to

ComSet32.exe

in the Startup folder. If

you select this option (YES), your PCI-COM232 hardware configuration is maintained across reboots. If

you select NO, at each reboot the PCI-COM232 board is restored to its default configuration.

Note: For most applications, the default settings for the hardware are adequate and allow the board to

operate at up to 115.2 kbaud.

If you selected NO during installation, when prompted about installing

ComSet32.exe

, then you can

manually create a shortcut and copy it to your Startup menu. The

ComSet32.exe

application is installed in

the directory specified during installation. The default installation directory is C:\cb. To create a shortcut,

do the following:

Start the “Windows Explorer” application and open the installation directory.

Right click on the

“ComSet32.exe”

entry.

Select the

“Create Shortcut”

option from the drop down menu.

Copy the shortcut to the Startup folder (C:\Windows\Start Menu\Programs\Startup).

To keep the

ComSet32.exe

window from popping up during execution, set the shortcut to execute

minimized. To set this option, do the following:

Right click on the shortcut icon and select Properties.

Select the shortcut tab.

Set the option labeled Run to

“Minimized”.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Measurement-computing PCI-COM232 Bedienungsanleitung Seite 10