Measurement-computing PC104-DAS08 Bedienungsanleitung PDF herunterladen (Seite 5)

1 INSTALLATION

1.1 SOFTWARE INSTALLATION

Before you open your computer and install the board, install and run

Insta

Cal, the

installation, calibration and test utility included with your board.

Insta

Cal will guide

you through switch and jumper settings for your board. Detailed information

regarding these settings can be found below. Refer to the

Software Installation

Manual

for

Insta

Cal installation instructions.

1.2 HARDWARE INSTALLATION

The PC104-DAS08 has three sets of switches / jumpers that should be set before

installing the board in the PC. There is a bank of DIP switches for setting the base

address, a jumper for setting the interrupt level and a bank of switches for setting the

analog input range. See Figure 1-1 below.

Figure 1-1. Switch and Jumper Locations

RANGE SELECT

SWITCHES (S2)

INTERRUPT LEVEL

SELECT JUMPERS

X (NO IRQ) SHOWN

ADDRESS SELECT

SWITCHES

Default 300h shown

PIN 1

(UNDER)

1 2 3 4 5 6 7 8 9 10 ... 23 24

Keine Kommentare

Measurement-computing PC104-DAS08 Bedienungsanleitung Seite 5