
Specifications – DaqBoard/1000 Series Boards 6
I/O Comparison Matrix
for DaqBoard/1000 Series Boards
DaqBoard
Identity
Analog Input
Channels
Analog Output
Channels
Digital I/O
Channels
Counter
Inputs
Timer
Outputs
1000 16
2
24
4
2
1005 16
-- 24
4
2
General Specifications Applicable to DaqBoard/1000, /1005
Warm-up: 1 hour to rated specifications
Supply voltage range: 4.75 VDC to 5.25 VDC (PCI bus)
Power consumption (per board): 3.5 W
Operating temperature: 0 to +60°C
Storage temperature: -40 to +80°C
Relative Humidity: 0 to 95% non-condensing
Vibration: MIL STD 810E
Signal I/O Connector: 68-pin SCSI type III, carries all analog I/O and digital I/O
Dimensions: 165 mm W x 15 mm D x 108 mm H (6.5” x 0.6” x 4.2”)
Weight: 160 g (0.35 lbs)
Analog Inputs Applicable to DaqBoard/1000, /1005
Channels: 16 single-ended or 8 differential, programmable on a per-channel basis as single-
ended or differential bipolar.
Bandwidth: 500 kHz
Settling Time: 5 µs maximum to 1 LSB for full-scale step
Maximum Input Voltage: +11V relative to analog common
Over-Voltage Protection: ±35V
Ranges:
Software programmable via sequencer on a per-channel basis.
Accuracy (Note 2)
One Year, 0 to 35°C
±(% reading + % range)
Input Noise (Note 3)
(LSB rms)
10 Hz to 200 kHz
Voltage Range
(Note 1)
Absolute Typical
-10 to +10 V 0.015+.005 1
-5 to +5 V 0.015+.005 1
-2.5 to +2.5 V 0.015+.005 1
-1.25 to +1.25 V 0.015+.005 2
-0.625 to +0.625 V 0.015+.008 2
-0.3125 to +0.3125 V 0.015+.008 3
-0.156 to +0.156 V 0.02+.008 3
Notes:
1) Specifications assume differential input single channel scan, 200 kHz scan rate, unfiltered.
2) Accuracy specification is exclusive of noise. Measurements were taken at P1.
3) Inputs shorted to signal ground (SGND). 8192 samples.
Note: Specifications subject to change without notice. 889094 Specifications – DaqBoard/1000 Series 6-1
Kommentare zu diesen Handbüchern