Measurement-computing Daq PC-Card Bedienungsanleitung PDF herunterladen (Seite 33)

Daq* Hardware DaqBook/100, /112, /120, /200, /216

DaqBook/DaqBoard/Daq PC-Card User’s Manual

10-18-00

3-3

DaqBook Controls and Connectors

Switch

POWER Depressing the “1” side of this rocker-arm switch turns the power on.

Connectors

POWER INPUT This DIN5 input connector accepts +7 to 20 VDC for the /100, /112, /120;

+10 to 24 VDC for the /216; +9 to 18 VDC for the /200, /260.

TO PARALLEL PRINTER This port allows the computer to use any standard parallel printer in a

pass-through mode (DB25).

FROM PC PARALLEL PORT This port connects to the computer’s standard or enhanced parallel port

(DB25).

P1 - ANALOG I/O Provides sixteen analog input channels, two analog output channels,

two 16-bit counter/timers, four TTL inputs and outputs, and various signals

for driving expansion cards (DB37).

P2 - DIGITAL I/O Provides three 8-bit TTL programmable I/O ports and external interrupt input

(DB37).

P3 - FREQUENCY I/O Provides five 16-bit counters and sixteen high-speed digital inputs and

external interrupt input (DB37).

Indicators

POWER This LED lights when power is applied to the DaqBook and the power switch

is in the “1” (ON) position.

P1-P2-P3 ACTIVE This LED lights when the DaqBook is in an active state. This LED is off

when the DaqBook is disabled or in the printer-pass-through mode. P1,

P2, and P3 are software accessible from the computer.

BUFFER OVERRUN This LED lights for a buffer overrun error. This occurs when A/D signals are

converted faster than the PC collects the data. Depending on the

application, this indication may not be an error.

A/D ACTIVE This LED lights during an A/D scan sequence. If the sequence has a low

number of steps and occurs infrequently, this indicator will only flash

briefly.

Jumpers

Proper installation requires that several jumpers and switches be set correctly for your application. These

jumpers and switches are located inside the DaqBook enclosure and possibly on your DBKs. Jumpers for

the various DaqBook models are configured similarly except for the jumpers’ relative locations. Silk-

screening on the motherboard identifies jumpers and switches. Note: Even if using the default settings, you

should verify actual jumper positions.

The DaqBook configuration jumpers include:

•

JP1 - External Analog Expansion Power

•

JP2 - DAC Voltage Reference

•

JP3* - Unipolar/Bipolar

•

JP4* - Differential/Single Ended

•

JP5 - Time Base

•

JP6 - Watchdog Timer Enable

•

JP7 - Calibration (refer to Chapter 12, Calibration)

* The DaqBook/200, /216, and /260 do not have JP3 and JP4 jumpers—these settings are made via

software.

Location of DaqBook Jumpers

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Measurement-computing Daq PC-Card Bedienungsanleitung Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Measurement-computing Daq PC-Card