Measurement-computing CIO-DAS48-PGA Bedienungsanleitung PDF herunterladen (Seite 11)

CIO-DAS48-PGA User's Guide Installing the CIO-DAS48-PGA

DIFF/SINGLE

The differential/single ended mode switch (Figure 4) sets board logic for 48 single-ended channels (48 SINGLE

position) or 24 differential channels (24 DIFF position). If the board is configured for current measurements, set

the V-I jumper to I, and then set the input mode switch to 24 DIFF.

In voltage mode, (V-I jumper "V" position), the board can be used for either single-ended or differential

voltage measurements.

SINGLE

DIFF

Figure 4. Input mode switch

Installing the CIO-DAS48-PGA

After you configure the board's switches and jumpers, you can install the CIO-DAS48-PGA into your

computer. To install your board, follow the steps below.

Install the MCC DAQ software before you install your board

The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install

the MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on

installing the software.

1. Turn your computer off, open it up, and insert your board into an available ISA slot.

2. Close your computer and turn it on.

3. To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connector, applicable cables, and compatible accessory products.

Board connector, cables, and accessory equipment

Connector type

50-pin header connector

Compatible cable

C50FF-x

Compatible accessory products with

the C50FF-x cable

CIO-MINI50

CIO-SPADE50

Information on signal connections

General information regarding signal connection and configuration is available in the Guide to Signal

Connections (available at www.mccdaq.com/signals/signals.pdf).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Measurement-computing CIO-DAS48-PGA Bedienungsanleitung Seite 11