Measurement-computing CIO-DAS08/JR Bedienungsanleitung PDF herunterladen (Seite 9)

CIO-DAS08/JR User's Guide Installing the CIO-DAS08/JR

Unpacking the CIO-DAS08/JR

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the CIO-DAS08/JR from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

 Fax: 508-946-9500 to the attention of Tech Support

 Email: [email protected]

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Configuring the CIO-DAS08/JR

Before you install the CIO-DAS08/JR in your computer, you must set the base address by using the dip switch

labeled ADDRESS located on the board. By default, this address is set to 300 h (768 decimal). The easiest way

to set the base address switch is to let InstaCal show you the correct settings. However, if are already familiar

with setting ISA base addresses, you may use the base address switch description below to guide your base

address selection. The example shown in Figure 1 shows the settings for the factory-default base address of 300

hex.

HEX

200

100

Figure 1. Base address switches

The address logic works by adding up the weights of individual switches to make up a base address. In the

default configuration shown in Figure 1, addresses 9 and 8 are DOWN, and all others are UP.

Address 9 = 200 hex (512 decimal) and address 8 = 100 hex (256 decimal); when added together they equal

300 hex (768 decimal).

Disregard the numbers printed on the switch

When setting the base address, refer to the numbers printed in white on the printed circuit board.

PC I/O addresses

Hex Range

Function

Hex Range

Function

000-00F

8237 DMA #1

2C0-2CF

EGA

020-021

8259 PIC#1

2D0-2DF

EGA

040-043

8253 Timer

2E0-2E7

GPIB (AT)

060-063

8255 PPI (XT)

2E8-2EF

Serial Port

060-064

8742 Controller (AT)

2F8-2FF

Serial Port

070-071

CMOS RAM & NMI mask (AT)

300-30F

Prototype card

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Measurement-computing CIO-DAS08/JR Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Measurement-computing CIO-DAS08/JR