Measurement-computing CIO-DAC08 Bedienungsanleitung PDF herunterladen (Seite 9)

CIO-DAC08 User's Guide Installing the CIO-DAC08

Unpacking the CIO-DAC08

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the CIO-DAC08 from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

 Fax: 508-946-9500 to the attention of Tech Support

 Email: techsupport@mccdaq.com

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Configuring the CIO-DAC08

The CIO-DAC08 has one base address switch, one bank of gain switches for each analog output channel, a

simultaneous update jumper for each DAC pair, a "power-up state" selection jumper, and one wait state jumper

which you must set before installing the board in your computer. The InstaCal calibration and test program

included with the CIO-DAC08 will show you how to set the switches. Run InstaCal before you open your

computer and install the board.

The CIO-DAC08 is shipped with the factory-default settings listed below.

Factory-configured default settings

Board label Switch/jumper description Default setting

ADDRESS

DIP switch for setting the base address 300h (768 decimal)

WAIT STATE

Jumper to enable a wait state OFF position

XFER

Jumper to select simultaneous or single channel

update for each DAC channel pair

Single channel update

0 through 7

DIP switches to set the analog output range ±5V

PWR UP

Jumper to select the power up and reset state STD position — standard (undefined

output values at power up)

Before installing the CIO-DAC08 in the computer, verify that the board is configured with the settings that you

want. Review the following information to change the default configuration of a jumper or switch on the CIO-

DAC08 board.

Base address switch

Before you install the CIO-DAC08 in your computer, set the base address by using the dip switch labeled

ADDRESS located on the board.

The easiest way to set the base address switch is to let InstaCAL show you the correct settings. However, if are

already familiar with setting ISA base addresses, you may use the base address switch description below to

guide your base address selection.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Measurement-computing CIO-DAC08 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Measurement-computing CIO-DAC08